bluetooth-next pull request for net-next:

core:

 - HCI: Add support for Shorter Connection Interval (SCI) feature
 - af_bluetooth: Add minimal context analysis annotations

drivers:

 - btusb: Add ASUS USB-BT540 for Realtek 8761CU
 - btusb: Add ASUS USB-BT600 for Realtek 8761CU
 - btusb: Add USB ID 13d3:3625 for MediaTek MT7922
 - btusb: Add support for 1357:c123 Realtek 8852BE device
 - btusb: Add new VID/PID 0x0489/0xe156 for MT7902
 - btintel: Add Bluetooth SAR revision 2 support
 - btintel_pcie: Add vendor_reset PCI sysfs for PLDR
 - btnxpuart: Add M.2 Bluetooth device support using pwrseq

Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept

rfcomm_sock_recvmsg() completes a deferred setup by calling
rfcomm_dlc_accept() without holding any RFCOMM lock:

	if (test_and_clear_bit(RFCOMM_DEFER_SETUP, &d->flags)) {
		rfcomm_dlc_accept(d);
		return 0;
	}

and rfcomm_dlc_accept() dereferences the session on its first line:

	struct sock *sk = d->session->sock->sk;

Every other path that touches d->session runs under rfcomm_mutex:
rfcomm_dlc_open(), rfcomm_dlc_close(), rfcomm_dlc_exists(),
rfcomm_dlc_send_rpn(), and the RFCOMM thread through
rfcomm_process_sessions(). rfcomm_connect_ind() is even documented as
"called under rfcomm_lock()". This call site is the only one that skips
it.

The RFCOMM_DEFER_SETUP bit looks like it serialises the accept against
teardown, since __rfcomm_dlc_close() returns early when it wins the
test_and_clear. But rfcomm_recv_disc() forces the state first:

	d->state = BT_CLOSED;
	__rfcomm_dlc_close(d, err);

and the early return only covers BT_CONNECT, BT_CONFIG, BT_OPEN and
BT_CONNECT2. With the state already BT_CLOSED that switch does not
match, the bit is never consulted, and __rfcomm_dlc_close() falls
through to rfcomm_dlc_unlink(), which sets d->session = NULL.

So a remote DISC on a deferred dlc clears the session while leaving
RFCOMM_DEFER_SETUP set. The next recvmsg() then passes the
test_and_clear and dereferences a NULL session. No timing window is
needed: once the DISC has been processed, the dereference is
unconditional.

Give rfcomm_dlc_accept() the same shape as rfcomm_dlc_open() and
rfcomm_dlc_close(): an exported wrapper that takes rfcomm_mutex and
re-checks the session, around a __rfcomm_dlc_accept() that the two
in-core callers, which already hold the mutex, keep using.

Reproduced on a KASAN + PROVE_LOCKING kernel with a BR/EDR peer emulated
over /dev/vhci: the peer brings up an ACL link, opens L2CAP on the
RFCOMM PSM, starts a session, opens a dlc on a channel bound with
BT_DEFER_SETUP, and sends DISC after the socket is accepted. recv() on
the accepted socket then hits:

  Oops: general protection fault
  KASAN: null-ptr-deref in range [0x0000000000000010-0x0000000000000017]
  RIP: 0010:rfcomm_dlc_accept+0x54/0x350
  Call Trace:
    rfcomm_sock_recvmsg+0x1cd/0x230
    sock_recvmsg+0x166/0x1c0
    __sys_recvfrom+0x20d/0x300

0x10 is the offset of sock in struct rfcomm_session. With this patch the
same run completes with recv() returning 0 and no report, and lockdep
stays quiet, confirming rfcomm_mutex is still taken before lock_sock on
this path as it is on the thread side.

Fixes: bb23c0ab8246 ("Bluetooth: Add support for deferring RFCOMM connection setup")
Cc: stable@vger.kernel.org
Signed-off-by: Ali Ahmet Memis <ali@iusegentoo.com>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>