blob: 990b20bffe473e27933a93d72d60cb974ac98bef [file] [log] [blame]
/*
* arch/v850/kernel/rte_nb85e_cb.c -- Midas labs RTE-V850E/NB85E-CB board
*
* Copyright (C) 2001,02,03 NEC Electronics Corporation
* Copyright (C) 2001,02,03 Miles Bader <miles@gnu.org>
*
* This file is subject to the terms and conditions of the GNU General
* Public License. See the file COPYING in the main directory of this
* archive for more details.
*
* Written by Miles Bader <miles@gnu.org>
*/
#include <linux/config.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/mm.h>
#include <linux/swap.h>
#include <linux/bootmem.h>
#include <linux/irq.h>
#include <asm/atomic.h>
#include <asm/page.h>
#include <asm/v850e.h>
#include <asm/rte_nb85e_cb.h>
#include "mach.h"
void __init mach_early_init (void)
{
/* Configure caching; some possible settings:
BHC = 0x0000, DCC = 0x0000 -- all caching disabled
BHC = 0x0040, DCC = 0x0000 -- SDRAM: icache only
BHC = 0x0080, DCC = 0x0C00 -- SDRAM: write-back dcache only
BHC = 0x00C0, DCC = 0x0C00 -- SDRAM: icache + write-back dcache
BHC = 0x00C0, DCC = 0x0800 -- SDRAM: icache + write-thru dcache
We can only cache SDRAM (we can't use cache SRAM because it's in
the same memory region as the on-chip RAM and I/O space).
Unfortunately, the dcache seems to be buggy, so we only use the
icache for now. */
v850e_cache_enable (0x0040 /*BHC*/, 0x0003 /*ICC*/, 0x0000 /*DCC*/);
rte_cb_early_init ();
}
void __init mach_get_physical_ram (unsigned long *ram_start,
unsigned long *ram_len)
{
/* We just use SDRAM here. */
*ram_start = SDRAM_ADDR;
*ram_len = SDRAM_SIZE;
}
void mach_gettimeofday (struct timespec *tv)
{
tv->tv_sec = 0;
tv->tv_nsec = 0;
}
/* Called before configuring an on-chip UART. */
void rte_nb85e_cb_uart_pre_configure (unsigned chan,
unsigned cflags, unsigned baud)
{
/* The RTE-NB85E-CB connects some general-purpose I/O pins on the
CPU to the RTS/CTS lines the UART's serial connection, as follows:
P00 = CTS (in), P01 = DSR (in), P02 = RTS (out), P03 = DTR (out). */
TEG_PORT0_PM = 0x03; /* P00 and P01 inputs, P02 and P03 outputs */
TEG_PORT0_IO = 0x03; /* Accept input */
/* Do pre-configuration for the actual UART. */
teg_uart_pre_configure (chan, cflags, baud);
}
void __init mach_init_irqs (void)
{
teg_init_irqs ();
rte_cb_init_irqs ();
}