Kernel driver bel-pfe
======================

Supported chips:

  * BEL PFE1100

    Prefixes: 'pfe1100'

    Addresses scanned: -

    Datasheet: https://www.belfuse.com/resources/datasheets/powersolutions/ds-bps-pfe1100-12-054xa.pdf

  * BEL PFE3000

    Prefixes: 'pfe3000'

    Addresses scanned: -

    Datasheet: https://www.belfuse.com/resources/datasheets/powersolutions/ds-bps-pfe3000-series.pdf

Author: Tao Ren <rentao.bupt@gmail.com>


Description
-----------

This driver supports hardware monitoring for below power supply devices
which support PMBus Protocol:

  * BEL PFE1100

    1100 Watt AC to DC power-factor-corrected (PFC) power supply.
    PMBus Communication Manual is not publicly available.

  * BEL PFE3000

    3000 Watt AC/DC power-factor-corrected (PFC) and DC-DC power supply.
    PMBus Communication Manual is not publicly available.

The driver is a client driver to the core PMBus driver. Please see
Documentation/hwmon/pmbus.rst for details on PMBus client drivers.


Usage Notes
-----------

This driver does not auto-detect devices. You will have to instantiate the
devices explicitly. Please see Documentation/i2c/instantiating-devices.rst for
details.

Example: the following will load the driver for an PFE3000 at address 0x20
on I2C bus #1::

	$ modprobe bel-pfe
	$ echo pfe3000 0x20 > /sys/bus/i2c/devices/i2c-1/new_device


Platform data support
---------------------

The driver supports standard PMBus driver platform data.


Sysfs entries
-------------

======================= =======================================================
curr1_label		"iin"
curr1_input		Measured input current
curr1_max               Input current max value
curr1_max_alarm         Input current max alarm

curr[2-3]_label		"iout[1-2]"
curr[2-3]_input		Measured output current
curr[2-3]_max           Output current max value
curr[2-3]_max_alarm     Output current max alarm

fan[1-2]_input          Fan 1 and 2 speed in RPM
fan1_target             Set fan speed reference for both fans

in1_label		"vin"
in1_input		Measured input voltage
in1_crit		Input voltage critical max value
in1_crit_alarm		Input voltage critical max alarm
in1_lcrit               Input voltage critical min value
in1_lcrit_alarm         Input voltage critical min alarm
in1_max                 Input voltage max value
in1_max_alarm           Input voltage max alarm

in2_label               "vcap"
in2_input               Hold up capacitor voltage

in[3-8]_label		"vout[1-3,5-7]"
in[3-8]_input		Measured output voltage
in[3-4]_alarm           vout[1-2] output voltage alarm

power[1-2]_label	"pin[1-2]"
power[1-2]_input        Measured input power
power[1-2]_alarm	Input power high alarm

power[3-4]_label	"pout[1-2]"
power[3-4]_input	Measured output power

temp[1-3]_input		Measured temperature
temp[1-3]_alarm         Temperature alarm
======================= =======================================================

.. note::

    - curr3, fan2, vout[2-7], vcap, pin2, pout2 and temp3 attributes only
      exist for PFE3000.