blob: 9ce22551b2b3ea2aa7dff3d0819093114dc421a3 [file] [log] [blame]
TI DA8xx MUSB
~~~~~~~~~~~~~
For DA8xx/OMAP-L1x/AM17xx/AM18xx platforms.
Required properties:
~~~~~~~~~~~~~~~~~~~~
- compatible : Should be set to "ti,da830-musb".
- reg: Offset and length of the USB controller register set.
- interrupts: The USB interrupt number.
- interrupt-names: Should be set to "mc".
- dr_mode: The USB operation mode. Should be one of "host", "peripheral" or "otg".
- phys: Phandle for the PHY device
- phy-names: Should be "usb-phy"
- dmas: specifies the dma channels
- dma-names: specifies the names of the channels. Use "rxN" for receive
and "txN" for transmit endpoints. N specifies the endpoint number.
Optional properties:
~~~~~~~~~~~~~~~~~~~~
- vbus-supply: Phandle to a regulator providing the USB bus power.
DMA
~~~
- compatible: ti,da830-cppi41
- reg: offset and length of the following register spaces: CPPI DMA Controller,
CPPI DMA Scheduler, Queue Manager
- reg-names: "controller", "scheduler", "queuemgr"
- #dma-cells: should be set to 2. The first number represents the
channel number (0 3 for endpoints 1 4).
The second number is 0 for RX and 1 for TX transfers.
- #dma-channels: should be set to 4 representing the 4 endpoints.
Example:
usb_phy: usb-phy {
compatible = "ti,da830-usb-phy";
#phy-cells = <0>;
};
usb0: usb@200000 {
compatible = "ti,da830-musb";
reg = <0x00200000 0x1000>;
ranges;
#address-cells = <1>;
#size-cells = <1>;
interrupts = <58>;
interrupt-names = "mc";
dr_mode = "host";
vbus-supply = <&usb_vbus>;
phys = <&usb_phy 0>;
phy-names = "usb-phy";
dmas = <&cppi41dma 0 0 &cppi41dma 1 0
&cppi41dma 2 0 &cppi41dma 3 0
&cppi41dma 0 1 &cppi41dma 1 1
&cppi41dma 2 1 &cppi41dma 3 1>;
dma-names =
"rx1", "rx2", "rx3", "rx4",
"tx1", "tx2", "tx3", "tx4";
cppi41dma: dma-controller@201000 {
compatible = "ti,da830-cppi41";
reg = <0x201000 0x1000
0x202000 0x1000
0x204000 0x4000>;
reg-names = "controller", "scheduler", "queuemgr";
interrupts = <58>;
#dma-cells = <2>;
#dma-channels = <4>;
};
};