blob: 6b02a0657ad9794265e65539da57cc65c7e86242 [file] [log] [blame]
Cadence MIPI-CSI2 RX controller
===============================
The Cadence MIPI-CSI2 RX controller is a CSI-2 bridge supporting up to 4 CSI
lanes in input, and 4 different pixel streams in output.
Required properties:
- compatible: must be set to "cdns,csi2rx" and an SoC-specific compatible
- reg: base address and size of the memory mapped region
- clocks: phandles to the clocks driving the controller
- clock-names: must contain:
* sys_clk: main clock
* p_clk: register bank clock
* pixel_if[0-3]_clk: pixel stream output clock, one for each stream
implemented in hardware, between 0 and 3
Optional properties:
- phys: phandle to the external D-PHY, phy-names must be provided
- phy-names: must contain "dphy", if the implementation uses an
external D-PHY
Required subnodes:
- ports: A ports node with one port child node per device input and output
port, in accordance with the video interface bindings defined in
Documentation/devicetree/bindings/media/video-interfaces.txt. The
port nodes are numbered as follows:
Port Description
-----------------------------
0 CSI-2 input
1 Stream 0 output
2 Stream 1 output
3 Stream 2 output
4 Stream 3 output
The stream output port nodes are optional if they are not
connected to anything at the hardware level or implemented
in the design.Since there is only one endpoint per port,
the endpoints are not numbered.
Example:
csi2rx: csi-bridge@0d060000 {
compatible = "cdns,csi2rx";
reg = <0x0d060000 0x1000>;
clocks = <&byteclock>, <&byteclock>
<&coreclock>, <&coreclock>,
<&coreclock>, <&coreclock>;
clock-names = "sys_clk", "p_clk",
"pixel_if0_clk", "pixel_if1_clk",
"pixel_if2_clk", "pixel_if3_clk";
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
csi2rx_in_sensor: endpoint {
remote-endpoint = <&sensor_out_csi2rx>;
clock-lanes = <0>;
data-lanes = <1 2>;
};
};
port@1 {
reg = <1>;
csi2rx_out_grabber0: endpoint {
remote-endpoint = <&grabber0_in_csi2rx>;
};
};
port@2 {
reg = <2>;
csi2rx_out_grabber1: endpoint {
remote-endpoint = <&grabber1_in_csi2rx>;
};
};
port@3 {
reg = <3>;
csi2rx_out_grabber2: endpoint {
remote-endpoint = <&grabber2_in_csi2rx>;
};
};
port@4 {
reg = <4>;
csi2rx_out_grabber3: endpoint {
remote-endpoint = <&grabber3_in_csi2rx>;
};
};
};
};