blob: 4b8ff947762f24883dd0417e3d575e4e2f653c60 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0-only
/*
* Copyright (c) 2021, The Linux Foundation. All rights reserved.
*/
#include <linux/bitops.h>
#include <linux/i2c.h>
#include <linux/interrupt.h>
#include <linux/irq.h>
#include <linux/irqdomain.h>
#include <linux/module.h>
#include <linux/of_device.h>
#include <linux/of_platform.h>
#include <linux/pinctrl/consumer.h>
#include <linux/regmap.h>
#include <linux/slab.h>
#include <dt-bindings/mfd/qcom-pm8008.h>
#define I2C_INTR_STATUS_BASE 0x0550
#define INT_RT_STS_OFFSET 0x10
#define INT_SET_TYPE_OFFSET 0x11
#define INT_POL_HIGH_OFFSET 0x12
#define INT_POL_LOW_OFFSET 0x13
#define INT_LATCHED_CLR_OFFSET 0x14
#define INT_EN_SET_OFFSET 0x15
#define INT_EN_CLR_OFFSET 0x16
#define INT_LATCHED_STS_OFFSET 0x18
enum {
PM8008_MISC,
PM8008_TEMP_ALARM,
PM8008_GPIO1,
PM8008_GPIO2,
PM8008_NUM_PERIPHS,
};
#define PM8008_PERIPH_0_BASE 0x900
#define PM8008_PERIPH_1_BASE 0x2400
#define PM8008_PERIPH_2_BASE 0xC000
#define PM8008_PERIPH_3_BASE 0xC100
#define PM8008_TEMP_ALARM_ADDR PM8008_PERIPH_1_BASE
#define PM8008_GPIO1_ADDR PM8008_PERIPH_2_BASE
#define PM8008_GPIO2_ADDR PM8008_PERIPH_3_BASE
#define PM8008_STATUS_BASE (PM8008_PERIPH_0_BASE | INT_LATCHED_STS_OFFSET)
#define PM8008_MASK_BASE (PM8008_PERIPH_0_BASE | INT_EN_SET_OFFSET)
#define PM8008_UNMASK_BASE (PM8008_PERIPH_0_BASE | INT_EN_CLR_OFFSET)
#define PM8008_TYPE_BASE (PM8008_PERIPH_0_BASE | INT_SET_TYPE_OFFSET)
#define PM8008_ACK_BASE (PM8008_PERIPH_0_BASE | INT_LATCHED_CLR_OFFSET)
#define PM8008_POLARITY_HI_BASE (PM8008_PERIPH_0_BASE | INT_POL_HIGH_OFFSET)
#define PM8008_POLARITY_LO_BASE (PM8008_PERIPH_0_BASE | INT_POL_LOW_OFFSET)
#define PM8008_PERIPH_OFFSET(paddr) (paddr - PM8008_PERIPH_0_BASE)
static unsigned int p0_offs[] = {PM8008_PERIPH_OFFSET(PM8008_PERIPH_0_BASE)};
static unsigned int p1_offs[] = {PM8008_PERIPH_OFFSET(PM8008_PERIPH_1_BASE)};
static unsigned int p2_offs[] = {PM8008_PERIPH_OFFSET(PM8008_PERIPH_2_BASE)};
static unsigned int p3_offs[] = {PM8008_PERIPH_OFFSET(PM8008_PERIPH_3_BASE)};
static struct regmap_irq_sub_irq_map pm8008_sub_reg_offsets[] = {
REGMAP_IRQ_MAIN_REG_OFFSET(p0_offs),
REGMAP_IRQ_MAIN_REG_OFFSET(p1_offs),
REGMAP_IRQ_MAIN_REG_OFFSET(p2_offs),
REGMAP_IRQ_MAIN_REG_OFFSET(p3_offs),
};
static unsigned int pm8008_virt_regs[] = {
PM8008_POLARITY_HI_BASE,
PM8008_POLARITY_LO_BASE,
};
enum {
POLARITY_HI_INDEX,
POLARITY_LO_INDEX,
PM8008_NUM_VIRT_REGS,
};
static struct regmap_irq pm8008_irqs[] = {
REGMAP_IRQ_REG(PM8008_IRQ_MISC_UVLO, PM8008_MISC, BIT(0)),
REGMAP_IRQ_REG(PM8008_IRQ_MISC_OVLO, PM8008_MISC, BIT(1)),
REGMAP_IRQ_REG(PM8008_IRQ_MISC_OTST2, PM8008_MISC, BIT(2)),
REGMAP_IRQ_REG(PM8008_IRQ_MISC_OTST3, PM8008_MISC, BIT(3)),
REGMAP_IRQ_REG(PM8008_IRQ_MISC_LDO_OCP, PM8008_MISC, BIT(4)),
REGMAP_IRQ_REG(PM8008_IRQ_TEMP_ALARM, PM8008_TEMP_ALARM, BIT(0)),
REGMAP_IRQ_REG(PM8008_IRQ_GPIO1, PM8008_GPIO1, BIT(0)),
REGMAP_IRQ_REG(PM8008_IRQ_GPIO2, PM8008_GPIO2, BIT(0)),
};
static int pm8008_set_type_virt(unsigned int **virt_buf,
unsigned int type, unsigned long hwirq,
int reg)
{
switch (type) {
case IRQ_TYPE_EDGE_FALLING:
case IRQ_TYPE_LEVEL_LOW:
virt_buf[POLARITY_HI_INDEX][reg] &= ~pm8008_irqs[hwirq].mask;
virt_buf[POLARITY_LO_INDEX][reg] |= pm8008_irqs[hwirq].mask;
break;
case IRQ_TYPE_EDGE_RISING:
case IRQ_TYPE_LEVEL_HIGH:
virt_buf[POLARITY_HI_INDEX][reg] |= pm8008_irqs[hwirq].mask;
virt_buf[POLARITY_LO_INDEX][reg] &= ~pm8008_irqs[hwirq].mask;
break;
case IRQ_TYPE_EDGE_BOTH:
virt_buf[POLARITY_HI_INDEX][reg] |= pm8008_irqs[hwirq].mask;
virt_buf[POLARITY_LO_INDEX][reg] |= pm8008_irqs[hwirq].mask;
break;
default:
return -EINVAL;
}
return 0;
}
static struct regmap_irq_chip pm8008_irq_chip = {
.name = "pm8008_irq",
.main_status = I2C_INTR_STATUS_BASE,
.num_main_regs = 1,
.num_virt_regs = PM8008_NUM_VIRT_REGS,
.irqs = pm8008_irqs,
.num_irqs = ARRAY_SIZE(pm8008_irqs),
.num_regs = PM8008_NUM_PERIPHS,
.not_fixed_stride = true,
.sub_reg_offsets = pm8008_sub_reg_offsets,
.set_type_virt = pm8008_set_type_virt,
.status_base = PM8008_STATUS_BASE,
.mask_base = PM8008_MASK_BASE,
.unmask_base = PM8008_UNMASK_BASE,
.type_base = PM8008_TYPE_BASE,
.ack_base = PM8008_ACK_BASE,
.virt_reg_base = pm8008_virt_regs,
.num_type_reg = PM8008_NUM_PERIPHS,
};
static struct regmap_config qcom_mfd_regmap_cfg = {
.reg_bits = 16,
.val_bits = 8,
.max_register = 0xFFFF,
};
static int pm8008_init(struct regmap *regmap)
{
int rc;
/*
* Set TEMP_ALARM peripheral's TYPE so that the regmap-irq framework
* reads this as the default value instead of zero, the HW default.
* This is required to enable the writing of TYPE registers in
* regmap_irq_sync_unlock().
*/
rc = regmap_write(regmap, (PM8008_TEMP_ALARM_ADDR | INT_SET_TYPE_OFFSET), BIT(0));
if (rc)
return rc;
/* Do the same for GPIO1 and GPIO2 peripherals */
rc = regmap_write(regmap, (PM8008_GPIO1_ADDR | INT_SET_TYPE_OFFSET), BIT(0));
if (rc)
return rc;
rc = regmap_write(regmap, (PM8008_GPIO2_ADDR | INT_SET_TYPE_OFFSET), BIT(0));
return rc;
}
static int pm8008_probe_irq_peripherals(struct device *dev,
struct regmap *regmap,
int client_irq)
{
int rc, i;
struct regmap_irq_type *type;
struct regmap_irq_chip_data *irq_data;
rc = pm8008_init(regmap);
if (rc) {
dev_err(dev, "Init failed: %d\n", rc);
return rc;
}
for (i = 0; i < ARRAY_SIZE(pm8008_irqs); i++) {
type = &pm8008_irqs[i].type;
type->type_reg_offset = pm8008_irqs[i].reg_offset;
type->type_rising_val = pm8008_irqs[i].mask;
type->type_falling_val = pm8008_irqs[i].mask;
type->type_level_high_val = 0;
type->type_level_low_val = 0;
if (type->type_reg_offset == PM8008_MISC)
type->types_supported = IRQ_TYPE_EDGE_RISING;
else
type->types_supported = (IRQ_TYPE_EDGE_BOTH |
IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_LEVEL_LOW);
}
rc = devm_regmap_add_irq_chip(dev, regmap, client_irq,
IRQF_SHARED, 0, &pm8008_irq_chip, &irq_data);
if (rc) {
dev_err(dev, "Failed to add IRQ chip: %d\n", rc);
return rc;
}
return 0;
}
static int pm8008_probe(struct i2c_client *client)
{
int rc;
struct device *dev;
struct regmap *regmap;
dev = &client->dev;
regmap = devm_regmap_init_i2c(client, &qcom_mfd_regmap_cfg);
if (!regmap)
return -ENODEV;
i2c_set_clientdata(client, regmap);
if (of_property_read_bool(dev->of_node, "interrupt-controller")) {
rc = pm8008_probe_irq_peripherals(dev, regmap, client->irq);
if (rc)
dev_err(dev, "Failed to probe irq periphs: %d\n", rc);
}
return devm_of_platform_populate(dev);
}
static const struct of_device_id pm8008_match[] = {
{ .compatible = "qcom,pm8008", },
{ },
};
static struct i2c_driver pm8008_mfd_driver = {
.driver = {
.name = "pm8008",
.of_match_table = pm8008_match,
},
.probe_new = pm8008_probe,
};
module_i2c_driver(pm8008_mfd_driver);
MODULE_LICENSE("GPL v2");
MODULE_ALIAS("i2c:qcom-pm8008");