| # |
| # Acorn Network device configuration |
| # These are for Acorn's Expansion card network interfaces |
| # |
| config ARM_AM79C961A |
| bool "ARM EBSA110 AM79C961A support" |
| depends on NET_ETHERNET && ARM && ARCH_EBSA110 |
| select CRC32 |
| help |
| If you wish to compile a kernel for the EBSA-110, then you should |
| always answer Y to this. |
| |
| config ARM_ETHER1 |
| tristate "Acorn Ether1 support" |
| depends on NET_ETHERNET && ARM && ARCH_ACORN |
| help |
| If you have an Acorn system with one of these (AKA25) network cards, |
| you should say Y to this option if you wish to use it with Linux. |
| |
| config ARM_ETHER3 |
| tristate "Acorn/ANT Ether3 support" |
| depends on NET_ETHERNET && ARM && ARCH_ACORN |
| help |
| If you have an Acorn system with one of these network cards, you |
| should say Y to this option if you wish to use it with Linux. |
| |
| config ARM_ETHERH |
| tristate "I-cubed EtherH/ANT EtherM support" |
| depends on NET_ETHERNET && ARM && ARCH_ACORN |
| select CRC32 |
| help |
| If you have an Acorn system with one of these network cards, you |
| should say Y to this option if you wish to use it with Linux. |
| |
| config ARM_ETHER00 |
| tristate "Altera Ether00 support" |
| depends on NET_ETHERNET && ARM && ARCH_CAMELOT |
| help |
| This is the driver for Altera's ether00 ethernet mac IP core. Say |
| Y here if you want to build support for this into the kernel. It |
| is also available as a module (say M here) that can be inserted/ |
| removed from the kernel at the same time as the PLD is configured. |
| If this driver is running on an epxa10 development board then it |
| will generate a suitable hw address based on the board serial |
| number (MTD support is required for this). Otherwise you will |
| need to set a suitable hw address using ifconfig. |
