blob: 40549f496a81ccdfb59d49da32682ab8cba2107f [file] [log] [blame]
* Atmel I2S controller
Required properties:
- compatible: Should be "atmel,sama5d2-i2s".
- reg: Should be the physical base address of the controller and the
length of memory mapped region.
- interrupts: Should contain the interrupt for the controller.
- dmas: Should be one per channel name listed in the dma-names property,
as described in atmel-dma.txt and dma.txt files.
- dma-names: Two dmas have to be defined, "tx" and "rx".
This IP also supports one shared channel for both rx and tx;
if this mode is used, one "rx-tx" name must be used.
- clocks: Must contain an entry for each entry in clock-names.
Please refer to clock-bindings.txt.
- clock-names: Should be one of each entry matching the clocks phandles list:
- "pclk" (peripheral clock) Required.
- "gclk" (generated clock) Optional (1).
- "muxclk" (I2S mux clock) Optional (1).
Optional properties:
- pinctrl-0: Should specify pin control groups used for this controller.
- princtrl-names: Should contain only one value - "default".
(1) : Only the peripheral clock is required. The generated clock and the I2S
mux clock are optional and should only be set together, when Master Mode
is required.
Example:
i2s@f8050000 {
compatible = "atmel,sama5d2-i2s";
reg = <0xf8050000 0x300>;
interrupts = <54 IRQ_TYPE_LEVEL_HIGH 7>;
dmas = <&dma0
(AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) |
AT91_XDMAC_DT_PERID(31))>,
<&dma0
(AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) |
AT91_XDMAC_DT_PERID(32))>;
dma-names = "tx", "rx";
clocks = <&i2s0_clk>, <&i2s0_gclk>, <&i2s0muxck>;
clock-names = "pclk", "gclk", "muxclk";
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_i2s0_default>;
};