blob: 8c65e2176e942e8d29334b2097b3fa6535815917 [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0-only */
#ifndef _LMC_IOCTL_H_
#define _LMC_IOCTL_H_
/* $Id: lmc_ioctl.h,v 1.15 2000/04/06 12:16:43 asj Exp $ */
/*
* Copyright (c) 1997-2000 LAN Media Corporation (LMC)
* All rights reserved. www.lanmedia.com
*
* This code is written by:
* Andrew Stanley-Jones (asj@cban.com)
* Rob Braun (bbraun@vix.com),
* Michael Graff (explorer@vix.com) and
* Matt Thomas (matt@3am-software.com).
*/
#define LMCIOCGINFO SIOCDEVPRIVATE+3 /* get current state */
#define LMCIOCSINFO SIOCDEVPRIVATE+4 /* set state to user values */
#define LMCIOCGETLMCSTATS SIOCDEVPRIVATE+5
#define LMCIOCCLEARLMCSTATS SIOCDEVPRIVATE+6
#define LMCIOCDUMPEVENTLOG SIOCDEVPRIVATE+7
#define LMCIOCGETXINFO SIOCDEVPRIVATE+8
#define LMCIOCSETCIRCUIT SIOCDEVPRIVATE+9
#define LMCIOCUNUSEDATM SIOCDEVPRIVATE+10
#define LMCIOCRESET SIOCDEVPRIVATE+11
#define LMCIOCT1CONTROL SIOCDEVPRIVATE+12
#define LMCIOCIFTYPE SIOCDEVPRIVATE+13
#define LMCIOCXILINX SIOCDEVPRIVATE+14
#define LMC_CARDTYPE_UNKNOWN -1
#define LMC_CARDTYPE_HSSI 1 /* probed card is a HSSI card */
#define LMC_CARDTYPE_DS3 2 /* probed card is a DS3 card */
#define LMC_CARDTYPE_SSI 3 /* probed card is a SSI card */
#define LMC_CARDTYPE_T1 4 /* probed card is a T1 card */
#define LMC_CTL_CARDTYPE_LMC5200 0 /* HSSI */
#define LMC_CTL_CARDTYPE_LMC5245 1 /* DS3 */
#define LMC_CTL_CARDTYPE_LMC1000 2 /* SSI, V.35 */
#define LMC_CTL_CARDTYPE_LMC1200 3 /* DS1 */
#define LMC_CTL_OFF 0 /* generic OFF value */
#define LMC_CTL_ON 1 /* generic ON value */
#define LMC_CTL_CLOCK_SOURCE_EXT 0 /* clock off line */
#define LMC_CTL_CLOCK_SOURCE_INT 1 /* internal clock */
#define LMC_CTL_CRC_LENGTH_16 16
#define LMC_CTL_CRC_LENGTH_32 32
#define LMC_CTL_CRC_BYTESIZE_2 2
#define LMC_CTL_CRC_BYTESIZE_4 4
#define LMC_CTL_CABLE_LENGTH_LT_100FT 0 /* DS3 cable < 100 feet */
#define LMC_CTL_CABLE_LENGTH_GT_100FT 1 /* DS3 cable >= 100 feet */
#define LMC_CTL_CIRCUIT_TYPE_E1 0
#define LMC_CTL_CIRCUIT_TYPE_T1 1
/*
* IFTYPE defines
*/
#define LMC_PPP 1 /* use generic HDLC interface */
#define LMC_NET 2 /* use direct net interface */
#define LMC_RAW 3 /* use direct net interface */
/*
* These are not in the least IOCTL related, but I want them common.
*/
/*
* assignments for the GPIO register on the DEC chip (common)
*/
#define LMC_GEP_INIT 0x01 /* 0: */
#define LMC_GEP_RESET 0x02 /* 1: */
#define LMC_GEP_MODE 0x10 /* 4: */
#define LMC_GEP_DP 0x20 /* 5: */
#define LMC_GEP_DATA 0x40 /* 6: serial out */
#define LMC_GEP_CLK 0x80 /* 7: serial clock */
/*
* HSSI GPIO assignments
*/
#define LMC_GEP_HSSI_ST 0x04 /* 2: receive timing sense (deprecated) */
#define LMC_GEP_HSSI_CLOCK 0x08 /* 3: clock source */
/*
* T1 GPIO assignments
*/
#define LMC_GEP_SSI_GENERATOR 0x04 /* 2: enable prog freq gen serial i/f */
#define LMC_GEP_SSI_TXCLOCK 0x08 /* 3: provide clock on TXCLOCK output */
/*
* Common MII16 bits
*/
#define LMC_MII16_LED0 0x0080
#define LMC_MII16_LED1 0x0100
#define LMC_MII16_LED2 0x0200
#define LMC_MII16_LED3 0x0400 /* Error, and the red one */
#define LMC_MII16_LED_ALL 0x0780 /* LED bit mask */
#define LMC_MII16_FIFO_RESET 0x0800
/*
* definitions for HSSI
*/
#define LMC_MII16_HSSI_TA 0x0001
#define LMC_MII16_HSSI_CA 0x0002
#define LMC_MII16_HSSI_LA 0x0004
#define LMC_MII16_HSSI_LB 0x0008
#define LMC_MII16_HSSI_LC 0x0010
#define LMC_MII16_HSSI_TM 0x0020
#define LMC_MII16_HSSI_CRC 0x0040
/*
* assignments for the MII register 16 (DS3)
*/
#define LMC_MII16_DS3_ZERO 0x0001
#define LMC_MII16_DS3_TRLBK 0x0002
#define LMC_MII16_DS3_LNLBK 0x0004
#define LMC_MII16_DS3_RAIS 0x0008
#define LMC_MII16_DS3_TAIS 0x0010
#define LMC_MII16_DS3_BIST 0x0020
#define LMC_MII16_DS3_DLOS 0x0040
#define LMC_MII16_DS3_CRC 0x1000
#define LMC_MII16_DS3_SCRAM 0x2000
#define LMC_MII16_DS3_SCRAM_LARS 0x4000
/* Note: 2 pairs of LEDs where swapped by mistake
* in Xilinx code for DS3 & DS1 adapters */
#define LMC_DS3_LED0 0x0100 /* bit 08 yellow */
#define LMC_DS3_LED1 0x0080 /* bit 07 blue */
#define LMC_DS3_LED2 0x0400 /* bit 10 green */
#define LMC_DS3_LED3 0x0200 /* bit 09 red */
/*
* framer register 0 and 7 (7 is latched and reset on read)
*/
#define LMC_FRAMER_REG0_DLOS 0x80 /* digital loss of service */
#define LMC_FRAMER_REG0_OOFS 0x40 /* out of frame sync */
#define LMC_FRAMER_REG0_AIS 0x20 /* alarm indication signal */
#define LMC_FRAMER_REG0_CIS 0x10 /* channel idle */
#define LMC_FRAMER_REG0_LOC 0x08 /* loss of clock */
/*
* Framer register 9 contains the blue alarm signal
*/
#define LMC_FRAMER_REG9_RBLUE 0x02 /* Blue alarm failure */
/*
* Framer register 0x10 contains xbit error
*/
#define LMC_FRAMER_REG10_XBIT 0x01 /* X bit error alarm failure */
/*
* And SSI, LMC1000
*/
#define LMC_MII16_SSI_DTR 0x0001 /* DTR output RW */
#define LMC_MII16_SSI_DSR 0x0002 /* DSR input RO */
#define LMC_MII16_SSI_RTS 0x0004 /* RTS output RW */
#define LMC_MII16_SSI_CTS 0x0008 /* CTS input RO */
#define LMC_MII16_SSI_DCD 0x0010 /* DCD input RO */
#define LMC_MII16_SSI_RI 0x0020 /* RI input RO */
#define LMC_MII16_SSI_CRC 0x1000 /* CRC select - RW */
/*
* bits 0x0080 through 0x0800 are generic, and described
* above with LMC_MII16_LED[0123] _LED_ALL, and _FIFO_RESET
*/
#define LMC_MII16_SSI_LL 0x1000 /* LL output RW */
#define LMC_MII16_SSI_RL 0x2000 /* RL output RW */
#define LMC_MII16_SSI_TM 0x4000 /* TM input RO */
#define LMC_MII16_SSI_LOOP 0x8000 /* loopback enable RW */
/*
* Some of the MII16 bits are mirrored in the MII17 register as well,
* but let's keep thing separate for now, and get only the cable from
* the MII17.
*/
#define LMC_MII17_SSI_CABLE_MASK 0x0038 /* mask to extract the cable type */
#define LMC_MII17_SSI_CABLE_SHIFT 3 /* shift to extract the cable type */
/*
* And T1, LMC1200
*/
#define LMC_MII16_T1_UNUSED1 0x0003
#define LMC_MII16_T1_XOE 0x0004
#define LMC_MII16_T1_RST 0x0008 /* T1 chip reset - RW */
#define LMC_MII16_T1_Z 0x0010 /* output impedance T1=1, E1=0 output - RW */
#define LMC_MII16_T1_INTR 0x0020 /* interrupt from 8370 - RO */
#define LMC_MII16_T1_ONESEC 0x0040 /* one second square wave - ro */
#define LMC_MII16_T1_LED0 0x0100
#define LMC_MII16_T1_LED1 0x0080
#define LMC_MII16_T1_LED2 0x0400
#define LMC_MII16_T1_LED3 0x0200
#define LMC_MII16_T1_FIFO_RESET 0x0800
#define LMC_MII16_T1_CRC 0x1000 /* CRC select - RW */
#define LMC_MII16_T1_UNUSED2 0xe000
/* 8370 framer registers */
#define T1FRAMER_ALARM1_STATUS 0x47
#define T1FRAMER_ALARM2_STATUS 0x48
#define T1FRAMER_FERR_LSB 0x50
#define T1FRAMER_FERR_MSB 0x51 /* framing bit error counter */
#define T1FRAMER_LCV_LSB 0x54
#define T1FRAMER_LCV_MSB 0x55 /* line code violation counter */
#define T1FRAMER_AERR 0x5A
/* mask for the above AERR register */
#define T1FRAMER_LOF_MASK (0x0f0) /* receive loss of frame */
#define T1FRAMER_COFA_MASK (0x0c0) /* change of frame alignment */
#define T1FRAMER_SEF_MASK (0x03) /* severely errored frame */
/* 8370 framer register ALM1 (0x47) values
* used to determine link status
*/
#define T1F_SIGFRZ 0x01 /* signaling freeze */
#define T1F_RLOF 0x02 /* receive loss of frame alignment */
#define T1F_RLOS 0x04 /* receive loss of signal */
#define T1F_RALOS 0x08 /* receive analog loss of signal or RCKI loss of clock */
#define T1F_RAIS 0x10 /* receive alarm indication signal */
#define T1F_UNUSED 0x20
#define T1F_RYEL 0x40 /* receive yellow alarm */
#define T1F_RMYEL 0x80 /* receive multiframe yellow alarm */
#define LMC_T1F_WRITE 0
#define LMC_T1F_READ 1
typedef struct lmc_st1f_control {
int command;
int address;
int value;
char __user *data;
} lmc_t1f_control;
enum lmc_xilinx_c {
lmc_xilinx_reset = 1,
lmc_xilinx_load_prom = 2,
lmc_xilinx_load = 3
};
struct lmc_xilinx_control {
enum lmc_xilinx_c command;
int len;
char __user *data;
};
/* ------------------ end T1 defs ------------------- */
#define LMC_MII_LedMask 0x0780
#define LMC_MII_LedBitPos 7
#endif