| /* | |
| * pata_winbond.c - Winbond VLB ATA controllers | |
| * (C) 2006 Red Hat <alan@redhat.com> | |
| * | |
| * Support for the Winbond 83759A when operating in advanced mode. | |
| * Multichip mode is not currently supported. | |
| */ | |
| #include <linux/kernel.h> | |
| #include <linux/module.h> | |
| #include <linux/init.h> | |
| #include <linux/blkdev.h> | |
| #include <linux/delay.h> | |
| #include <scsi/scsi_host.h> | |
| #include <linux/libata.h> | |
| #include <linux/platform_device.h> | |
| #define DRV_NAME "pata_winbond" | |
| #define DRV_VERSION "0.0.3" | |
| #define NR_HOST 4 /* Two winbond controllers, two channels each */ | |
| struct winbond_data { | |
| unsigned long config; | |
| struct platform_device *platform_dev; | |
| }; | |
| static struct ata_host *winbond_host[NR_HOST]; | |
| static struct winbond_data winbond_data[NR_HOST]; | |
| static int nr_winbond_host; | |
| #ifdef MODULE | |
| static int probe_winbond = 1; | |
| #else | |
| static int probe_winbond; | |
| #endif | |
| static DEFINE_SPINLOCK(winbond_lock); | |
| static void winbond_writecfg(unsigned long port, u8 reg, u8 val) | |
| { | |
| unsigned long flags; | |
| spin_lock_irqsave(&winbond_lock, flags); | |
| outb(reg, port + 0x01); | |
| outb(val, port + 0x02); | |
| spin_unlock_irqrestore(&winbond_lock, flags); | |
| } | |
| static u8 winbond_readcfg(unsigned long port, u8 reg) | |
| { | |
| u8 val; | |
| unsigned long flags; | |
| spin_lock_irqsave(&winbond_lock, flags); | |
| outb(reg, port + 0x01); | |
| val = inb(port + 0x02); | |
| spin_unlock_irqrestore(&winbond_lock, flags); | |
| return val; | |
| } | |
| static void winbond_set_piomode(struct ata_port *ap, struct ata_device *adev) | |
| { | |
| struct ata_timing t; | |
| struct winbond_data *winbond = ap->host->private_data; | |
| int active, recovery; | |
| u8 reg; | |
| int timing = 0x88 + (ap->port_no * 4) + (adev->devno * 2); | |
| reg = winbond_readcfg(winbond->config, 0x81); | |
| /* Get the timing data in cycles */ | |
| if (reg & 0x40) /* Fast VLB bus, assume 50MHz */ | |
| ata_timing_compute(adev, adev->pio_mode, &t, 20000, 1000); | |
| else | |
| ata_timing_compute(adev, adev->pio_mode, &t, 30303, 1000); | |
| active = (FIT(t.active, 3, 17) - 1) & 0x0F; | |
| recovery = (FIT(t.recover, 1, 15) + 1) & 0x0F; | |
| timing = (active << 4) | recovery; | |
| winbond_writecfg(winbond->config, timing, reg); | |
| /* Load the setup timing */ | |
| reg = 0x35; | |
| if (adev->class != ATA_DEV_ATA) | |
| reg |= 0x08; /* FIFO off */ | |
| if (!ata_pio_need_iordy(adev)) | |
| reg |= 0x02; /* IORDY off */ | |
| reg |= (FIT(t.setup, 0, 3) << 6); | |
| winbond_writecfg(winbond->config, timing + 1, reg); | |
| } | |
| static void winbond_data_xfer(struct ata_device *adev, unsigned char *buf, unsigned int buflen, int write_data) | |
| { | |
| struct ata_port *ap = adev->ap; | |
| int slop = buflen & 3; | |
| if (ata_id_has_dword_io(adev->id)) { | |
| if (write_data) | |
| iowrite32_rep(ap->ioaddr.data_addr, buf, buflen >> 2); | |
| else | |
| ioread32_rep(ap->ioaddr.data_addr, buf, buflen >> 2); | |
| if (unlikely(slop)) { | |
| u32 pad; | |
| if (write_data) { | |
| memcpy(&pad, buf + buflen - slop, slop); | |
| pad = le32_to_cpu(pad); | |
| iowrite32(pad, ap->ioaddr.data_addr); | |
| } else { | |
| pad = ioread32(ap->ioaddr.data_addr); | |
| pad = cpu_to_le16(pad); | |
| memcpy(buf + buflen - slop, &pad, slop); | |
| } | |
| } | |
| } else | |
| ata_data_xfer(adev, buf, buflen, write_data); | |
| } | |
| static struct scsi_host_template winbond_sht = { | |
| .module = THIS_MODULE, | |
| .name = DRV_NAME, | |
| .ioctl = ata_scsi_ioctl, | |
| .queuecommand = ata_scsi_queuecmd, | |
| .can_queue = ATA_DEF_QUEUE, | |
| .this_id = ATA_SHT_THIS_ID, | |
| .sg_tablesize = LIBATA_MAX_PRD, | |
| .cmd_per_lun = ATA_SHT_CMD_PER_LUN, | |
| .emulated = ATA_SHT_EMULATED, | |
| .use_clustering = ATA_SHT_USE_CLUSTERING, | |
| .proc_name = DRV_NAME, | |
| .dma_boundary = ATA_DMA_BOUNDARY, | |
| .slave_configure = ata_scsi_slave_config, | |
| .slave_destroy = ata_scsi_slave_destroy, | |
| .bios_param = ata_std_bios_param, | |
| }; | |
| static struct ata_port_operations winbond_port_ops = { | |
| .port_disable = ata_port_disable, | |
| .set_piomode = winbond_set_piomode, | |
| .tf_load = ata_tf_load, | |
| .tf_read = ata_tf_read, | |
| .check_status = ata_check_status, | |
| .exec_command = ata_exec_command, | |
| .dev_select = ata_std_dev_select, | |
| .freeze = ata_bmdma_freeze, | |
| .thaw = ata_bmdma_thaw, | |
| .error_handler = ata_bmdma_error_handler, | |
| .post_internal_cmd = ata_bmdma_post_internal_cmd, | |
| .cable_detect = ata_cable_40wire, | |
| .qc_prep = ata_qc_prep, | |
| .qc_issue = ata_qc_issue_prot, | |
| .data_xfer = winbond_data_xfer, | |
| .irq_clear = ata_bmdma_irq_clear, | |
| .irq_on = ata_irq_on, | |
| .irq_ack = ata_irq_ack, | |
| .port_start = ata_port_start, | |
| }; | |
| /** | |
| * winbond_init_one - attach a winbond interface | |
| * @type: Type to display | |
| * @io: I/O port start | |
| * @irq: interrupt line | |
| * @fast: True if on a > 33Mhz VLB | |
| * | |
| * Register a VLB bus IDE interface. Such interfaces are PIO and we | |
| * assume do not support IRQ sharing. | |
| */ | |
| static __init int winbond_init_one(unsigned long port) | |
| { | |
| struct platform_device *pdev; | |
| u8 reg; | |
| int i, rc; | |
| reg = winbond_readcfg(port, 0x81); | |
| reg |= 0x80; /* jumpered mode off */ | |
| winbond_writecfg(port, 0x81, reg); | |
| reg = winbond_readcfg(port, 0x83); | |
| reg |= 0xF0; /* local control */ | |
| winbond_writecfg(port, 0x83, reg); | |
| reg = winbond_readcfg(port, 0x85); | |
| reg |= 0xF0; /* programmable timing */ | |
| winbond_writecfg(port, 0x85, reg); | |
| reg = winbond_readcfg(port, 0x81); | |
| if (!(reg & 0x03)) /* Disabled */ | |
| return 0; | |
| for (i = 0; i < 2 ; i ++) { | |
| unsigned long cmd_port = 0x1F0 - (0x80 * i); | |
| struct ata_host *host; | |
| struct ata_port *ap; | |
| void __iomem *cmd_addr, *ctl_addr; | |
| if (!(reg & (1 << i))) | |
| continue; | |
| pdev = platform_device_register_simple(DRV_NAME, nr_winbond_host, NULL, 0); | |
| if (IS_ERR(pdev)) | |
| return PTR_ERR(pdev); | |
| rc = -ENOMEM; | |
| host = ata_host_alloc(&pdev->dev, 1); | |
| if (!host) | |
| goto err_unregister; | |
| rc = -ENOMEM; | |
| cmd_addr = devm_ioport_map(&pdev->dev, cmd_port, 8); | |
| ctl_addr = devm_ioport_map(&pdev->dev, cmd_port + 0x0206, 1); | |
| if (!cmd_addr || !ctl_addr) | |
| goto err_unregister; | |
| ap = host->ports[0]; | |
| ap->ops = &winbond_port_ops; | |
| ap->pio_mask = 0x1F; | |
| ap->flags |= ATA_FLAG_SLAVE_POSS; | |
| ap->ioaddr.cmd_addr = cmd_addr; | |
| ap->ioaddr.altstatus_addr = ctl_addr; | |
| ap->ioaddr.ctl_addr = ctl_addr; | |
| ata_std_ports(&ap->ioaddr); | |
| /* hook in a private data structure per channel */ | |
| host->private_data = &winbond_data[nr_winbond_host]; | |
| winbond_data[nr_winbond_host].config = port; | |
| winbond_data[nr_winbond_host].platform_dev = pdev; | |
| /* activate */ | |
| rc = ata_host_activate(host, 14 + i, ata_interrupt, 0, | |
| &winbond_sht); | |
| if (rc) | |
| goto err_unregister; | |
| winbond_host[nr_winbond_host++] = dev_get_drvdata(&pdev->dev); | |
| } | |
| return 0; | |
| err_unregister: | |
| platform_device_unregister(pdev); | |
| return rc; | |
| } | |
| /** | |
| * winbond_init - attach winbond interfaces | |
| * | |
| * Attach winbond IDE interfaces by scanning the ports it may occupy. | |
| */ | |
| static __init int winbond_init(void) | |
| { | |
| static const unsigned long config[2] = { 0x130, 0x1B0 }; | |
| int ct = 0; | |
| int i; | |
| if (probe_winbond == 0) | |
| return -ENODEV; | |
| /* | |
| * Check both base addresses | |
| */ | |
| for (i = 0; i < 2; i++) { | |
| if (probe_winbond & (1<<i)) { | |
| int ret = 0; | |
| unsigned long port = config[i]; | |
| if (request_region(port, 2, "pata_winbond")) { | |
| ret = winbond_init_one(port); | |
| if(ret <= 0) | |
| release_region(port, 2); | |
| else ct+= ret; | |
| } | |
| } | |
| } | |
| if (ct != 0) | |
| return 0; | |
| return -ENODEV; | |
| } | |
| static __exit void winbond_exit(void) | |
| { | |
| int i; | |
| for (i = 0; i < nr_winbond_host; i++) { | |
| ata_host_detach(winbond_host[i]); | |
| release_region(winbond_data[i].config, 2); | |
| platform_device_unregister(winbond_data[i].platform_dev); | |
| } | |
| } | |
| MODULE_AUTHOR("Alan Cox"); | |
| MODULE_DESCRIPTION("low-level driver for Winbond VL ATA"); | |
| MODULE_LICENSE("GPL"); | |
| MODULE_VERSION(DRV_VERSION); | |
| module_init(winbond_init); | |
| module_exit(winbond_exit); | |
| module_param(probe_winbond, int, 0); | |