| /* SPDX-License-Identifier: GPL-2.0 */ | |
| /* Copyright (c) 2012-2018, The Linux Foundation. All rights reserved. | |
| * Copyright (C) 2019-2023 Linaro Ltd. | |
| */ | |
| #ifndef _IPA_ENDPOINT_H_ | |
| #define _IPA_ENDPOINT_H_ | |
| #include <linux/types.h> | |
| #include <linux/workqueue.h> | |
| #include <linux/if_ether.h> | |
| #include "gsi.h" | |
| #include "ipa_reg.h" | |
| struct net_device; | |
| struct sk_buff; | |
| struct ipa; | |
| struct ipa_gsi_endpoint_data; | |
| /* Non-zero granularity of counter used to implement aggregation timeout */ | |
| #define IPA_AGGR_GRANULARITY 500 /* microseconds */ | |
| #define IPA_MTU ETH_DATA_LEN | |
| enum ipa_endpoint_name { | |
| IPA_ENDPOINT_AP_COMMAND_TX, | |
| IPA_ENDPOINT_AP_LAN_RX, | |
| IPA_ENDPOINT_AP_MODEM_TX, | |
| IPA_ENDPOINT_AP_MODEM_RX, | |
| IPA_ENDPOINT_MODEM_COMMAND_TX, | |
| IPA_ENDPOINT_MODEM_LAN_TX, | |
| IPA_ENDPOINT_MODEM_LAN_RX, | |
| IPA_ENDPOINT_MODEM_AP_TX, | |
| IPA_ENDPOINT_MODEM_AP_RX, | |
| IPA_ENDPOINT_MODEM_DL_NLO_TX, | |
| IPA_ENDPOINT_COUNT, /* Number of names (not an index) */ | |
| }; | |
| #define IPA_ENDPOINT_MAX 36 /* Max supported by driver */ | |
| /** | |
| * struct ipa_endpoint_tx - Endpoint configuration for TX endpoints | |
| * @seq_type: primary packet processing sequencer type | |
| * @seq_rep_type: sequencer type for replication processing | |
| * @status_endpoint: endpoint to which status elements are sent | |
| * | |
| * The @status_endpoint is only valid if the endpoint's @status_enable | |
| * flag is set. | |
| */ | |
| struct ipa_endpoint_tx { | |
| enum ipa_seq_type seq_type; | |
| enum ipa_seq_rep_type seq_rep_type; | |
| enum ipa_endpoint_name status_endpoint; | |
| }; | |
| /** | |
| * struct ipa_endpoint_rx - Endpoint configuration for RX endpoints | |
| * @buffer_size: requested receive buffer size (bytes) | |
| * @pad_align: power-of-2 boundary to which packet payload is aligned | |
| * @aggr_time_limit: time before aggregation closes (microseconds) | |
| * @aggr_hard_limit: whether aggregation closes before or after boundary | |
| * @aggr_close_eof: whether aggregation closes on end-of-frame | |
| * @holb_drop: whether to drop packets to avoid head-of-line blocking | |
| * | |
| * The actual size of the receive buffer is rounded up if necessary | |
| * to be a power-of-2 number of pages. | |
| * | |
| * With each packet it transfers, the IPA hardware can perform certain | |
| * transformations of its packet data. One of these is adding pad bytes | |
| * to the end of the packet data so the result ends on a power-of-2 boundary. | |
| * | |
| * It is also able to aggregate multiple packets into a single receive buffer. | |
| * Aggregation is "open" while a buffer is being filled, and "closes" when | |
| * certain criteria are met. | |
| * | |
| * A time limit can be specified to close aggregation. Aggregation will be | |
| * closed if this period passes after data is first written into a receive | |
| * buffer. If not specified, no time limit is imposed. | |
| * | |
| * Insufficient space available in the receive buffer can close aggregation. | |
| * The aggregation byte limit defines the point (in units of 1024 bytes) in | |
| * the buffer where aggregation closes. With a "soft" aggregation limit, | |
| * aggregation closes when a packet written to the buffer *crosses* that | |
| * aggregation limit. With a "hard" aggregation limit, aggregation will | |
| * close *before* writing a packet that would cross that boundary. | |
| */ | |
| struct ipa_endpoint_rx { | |
| u32 buffer_size; | |
| u32 pad_align; | |
| u32 aggr_time_limit; | |
| bool aggr_hard_limit; | |
| bool aggr_close_eof; | |
| bool holb_drop; | |
| }; | |
| /** | |
| * struct ipa_endpoint_config - IPA endpoint hardware configuration | |
| * @resource_group: resource group to assign endpoint to | |
| * @checksum: whether checksum offload is enabled | |
| * @qmap: whether endpoint uses QMAP protocol | |
| * @aggregation: whether endpoint supports aggregation | |
| * @status_enable: whether endpoint uses status elements | |
| * @dma_mode: whether endpoint operates in DMA mode | |
| * @dma_endpoint: peer endpoint, if operating in DMA mode | |
| * @tx: TX-specific endpoint information (see above) | |
| * @rx: RX-specific endpoint information (see above) | |
| */ | |
| struct ipa_endpoint_config { | |
| u32 resource_group; | |
| bool checksum; | |
| bool qmap; | |
| bool aggregation; | |
| bool status_enable; | |
| bool dma_mode; | |
| enum ipa_endpoint_name dma_endpoint; | |
| union { | |
| struct ipa_endpoint_tx tx; | |
| struct ipa_endpoint_rx rx; | |
| }; | |
| }; | |
| /** | |
| * enum ipa_replenish_flag: RX buffer replenish flags | |
| * | |
| * @IPA_REPLENISH_ENABLED: Whether receive buffer replenishing is enabled | |
| * @IPA_REPLENISH_ACTIVE: Whether replenishing is underway | |
| * @IPA_REPLENISH_COUNT: Number of defined replenish flags | |
| */ | |
| enum ipa_replenish_flag { | |
| IPA_REPLENISH_ENABLED, | |
| IPA_REPLENISH_ACTIVE, | |
| IPA_REPLENISH_COUNT, /* Number of flags (must be last) */ | |
| }; | |
| /** | |
| * struct ipa_endpoint - IPA endpoint information | |
| * @ipa: IPA pointer | |
| * @ee_id: Execution environmnent endpoint is associated with | |
| * @channel_id: GSI channel used by the endpoint | |
| * @endpoint_id: IPA endpoint number | |
| * @toward_ipa: Endpoint direction (true = TX, false = RX) | |
| * @config: Default endpoint configuration | |
| * @skb_frag_max: Maximum allowed number of TX SKB fragments | |
| * @evt_ring_id: GSI event ring used by the endpoint | |
| * @netdev: Network device pointer, if endpoint uses one | |
| * @replenish_flags: Replenishing state flags | |
| * @replenish_count: Total number of replenish transactions committed | |
| * @replenish_work: Work item used for repeated replenish failures | |
| */ | |
| struct ipa_endpoint { | |
| struct ipa *ipa; | |
| enum gsi_ee_id ee_id; | |
| u32 channel_id; | |
| u32 endpoint_id; | |
| bool toward_ipa; | |
| struct ipa_endpoint_config config; | |
| u32 skb_frag_max; /* Used for netdev TX only */ | |
| u32 evt_ring_id; | |
| /* Net device this endpoint is associated with, if any */ | |
| struct net_device *netdev; | |
| /* Receive buffer replenishing for RX endpoints */ | |
| DECLARE_BITMAP(replenish_flags, IPA_REPLENISH_COUNT); | |
| u64 replenish_count; | |
| struct delayed_work replenish_work; /* global wq */ | |
| }; | |
| void ipa_endpoint_modem_hol_block_clear_all(struct ipa *ipa); | |
| void ipa_endpoint_modem_pause_all(struct ipa *ipa, bool enable); | |
| int ipa_endpoint_modem_exception_reset_all(struct ipa *ipa); | |
| int ipa_endpoint_skb_tx(struct ipa_endpoint *endpoint, struct sk_buff *skb); | |
| int ipa_endpoint_enable_one(struct ipa_endpoint *endpoint); | |
| void ipa_endpoint_disable_one(struct ipa_endpoint *endpoint); | |
| void ipa_endpoint_suspend_one(struct ipa_endpoint *endpoint); | |
| void ipa_endpoint_resume_one(struct ipa_endpoint *endpoint); | |
| void ipa_endpoint_suspend(struct ipa *ipa); | |
| void ipa_endpoint_resume(struct ipa *ipa); | |
| void ipa_endpoint_setup(struct ipa *ipa); | |
| void ipa_endpoint_teardown(struct ipa *ipa); | |
| int ipa_endpoint_config(struct ipa *ipa); | |
| void ipa_endpoint_deconfig(struct ipa *ipa); | |
| void ipa_endpoint_default_route_set(struct ipa *ipa, u32 endpoint_id); | |
| void ipa_endpoint_default_route_clear(struct ipa *ipa); | |
| int ipa_endpoint_init(struct ipa *ipa, u32 count, | |
| const struct ipa_gsi_endpoint_data *data); | |
| void ipa_endpoint_exit(struct ipa *ipa); | |
| void ipa_endpoint_trans_complete(struct ipa_endpoint *ipa, | |
| struct gsi_trans *trans); | |
| void ipa_endpoint_trans_release(struct ipa_endpoint *ipa, | |
| struct gsi_trans *trans); | |
| #endif /* _IPA_ENDPOINT_H_ */ |