blob: c73d1445c77ecfc13a4867f60444f6c3a1adc183 [file] [log] [blame]
/*
* Copyright (C) 2005 Stephen Street / StreetFire Sound Labs
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#ifndef __linux_pxa2xx_spi_h
#define __linux_pxa2xx_spi_h
#include <linux/pxa2xx_ssp.h>
#define PXA2XX_CS_ASSERT (0x01)
#define PXA2XX_CS_DEASSERT (0x02)
/* device.platform_data for SSP controller devices */
struct pxa2xx_spi_master {
u32 clock_enable;
u16 num_chipselect;
u8 enable_dma;
};
/* spi_board_info.controller_data for SPI slave devices,
* copied to spi_device.platform_data ... mostly for dma tuning
*/
struct pxa2xx_spi_chip {
u8 tx_threshold;
u8 rx_threshold;
u8 dma_burst_size;
u32 timeout;
u8 enable_loopback;
int gpio_cs;
void (*cs_control)(u32 command);
};
#if defined(CONFIG_ARCH_PXA) || defined(CONFIG_ARCH_MMP)
#include <linux/clk.h>
#include <mach/dma.h>
extern void pxa2xx_set_spi_info(unsigned id, struct pxa2xx_spi_master *info);
#else
/*
* This is the implemtation for CE4100 on x86. ARM defines them in mach/ or
* plat/ include path.
* The CE4100 does not provide DMA support. This bits are here to let the driver
* compile and will never be used. Maybe we get DMA support at a later point in
* time.
*/
#define DCSR(n) (n)
#define DSADR(n) (n)
#define DTADR(n) (n)
#define DCMD(n) (n)
#define DRCMR(n) (n)
#define DCSR_RUN (1 << 31) /* Run Bit */
#define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch */
#define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable */
#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
#define DCSR_ENDINTR (1 << 2) /* End Interrupt */
#define DCSR_STARTINTR (1 << 1) /* Start Interrupt */
#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt */
#define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable */
#define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */
#define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */
#define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */
#define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */
#define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */
#define DCSR_EORINTR (1 << 9) /* The end of Receive */
#define DRCMR_MAPVLD (1 << 7) /* Map Valid */
#define DRCMR_CHLNUM 0x1f /* mask for Channel Number */
#define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor */
#define DDADR_STOP (1 << 0) /* Stop */
#define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */
#define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */
#define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */
#define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */
#define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */
#define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */
#define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */
#define DCMD_BURST8 (1 << 16) /* 8 byte burst */
#define DCMD_BURST16 (2 << 16) /* 16 byte burst */
#define DCMD_BURST32 (3 << 16) /* 32 byte burst */
#define DCMD_WIDTH1 (1 << 14) /* 1 byte width */
#define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */
#define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */
#define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */
/*
* Descriptor structure for PXA's DMA engine
* Note: this structure must always be aligned to a 16-byte boundary.
*/
typedef enum {
DMA_PRIO_HIGH = 0,
DMA_PRIO_MEDIUM = 1,
DMA_PRIO_LOW = 2
} pxa_dma_prio;
/*
* DMA registration
*/
static inline int pxa_request_dma(char *name,
pxa_dma_prio prio,
void (*irq_handler)(int, void *),
void *data)
{
return -ENODEV;
}
static inline void pxa_free_dma(int dma_ch)
{
}
/*
* The CE4100 does not have the clk framework implemented and SPI clock can
* not be switched on/off or the divider changed.
*/
static inline void clk_disable(struct clk *clk)
{
}
static inline int clk_enable(struct clk *clk)
{
return 0;
}
static inline unsigned long clk_get_rate(struct clk *clk)
{
return 3686400;
}
#endif
#endif