blob: 1144e0c9e8942ddb6226a7f409ed07f25a0eb96a [file] [log] [blame]
/*
* Copyright (C) 2016 Marek Vasut <marex@denx.de>
*
* This code is based on drivers/video/fbdev/mxsfb.c :
* Copyright (C) 2010 Juergen Beisert, Pengutronix
* Copyright (C) 2008-2009 Freescale Semiconductor, Inc. All Rights Reserved.
* Copyright (C) 2008 Embedded Alley Solutions, Inc All Rights Reserved.
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* as published by the Free Software Foundation; either version 2
* of the License, or (at your option) any later version.
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*/
#include <drm/drmP.h>
#include <drm/drm_atomic_helper.h>
#include <drm/drm_crtc.h>
#include <drm/drm_crtc_helper.h>
#include <drm/drm_fb_helper.h>
#include <drm/drm_fb_cma_helper.h>
#include <drm/drm_gem_cma_helper.h>
#include <drm/drm_of.h>
#include <drm/drm_plane_helper.h>
#include <drm/drm_simple_kms_helper.h>
#include <linux/clk.h>
#include <linux/iopoll.h>
#include <linux/of_graph.h>
#include <linux/platform_data/simplefb.h>
#include <video/videomode.h>
#include "mxsfb_drv.h"
#include "mxsfb_regs.h"
static u32 set_hsync_pulse_width(struct mxsfb_drm_private *mxsfb, u32 val)
{
return (val & mxsfb->devdata->hs_wdth_mask) <<
mxsfb->devdata->hs_wdth_shift;
}
/* Setup the MXSFB registers for decoding the pixels out of the framebuffer */
static int mxsfb_set_pixel_fmt(struct mxsfb_drm_private *mxsfb)
{
struct drm_crtc *crtc = &mxsfb->pipe.crtc;
struct drm_device *drm = crtc->dev;
const u32 format = crtc->primary->state->fb->format->format;
u32 ctrl, ctrl1;
ctrl = CTRL_BYPASS_COUNT | CTRL_MASTER;
/*
* WARNING: The bus width, CTRL_SET_BUS_WIDTH(), is configured to
* match the selected mode here. This differs from the original
* MXSFB driver, which had the option to configure the bus width
* to arbitrary value. This limitation should not pose an issue.
*/
/* CTRL1 contains IRQ config and status bits, preserve those. */
ctrl1 = readl(mxsfb->base + LCDC_CTRL1);
ctrl1 &= CTRL1_CUR_FRAME_DONE_IRQ_EN | CTRL1_CUR_FRAME_DONE_IRQ;
switch (format) {
case DRM_FORMAT_RGB565:
dev_dbg(drm->dev, "Setting up RGB565 mode\n");
ctrl |= CTRL_SET_WORD_LENGTH(0);
ctrl1 |= CTRL1_SET_BYTE_PACKAGING(0xf);
break;
case DRM_FORMAT_XRGB8888:
dev_dbg(drm->dev, "Setting up XRGB8888 mode\n");
ctrl |= CTRL_SET_WORD_LENGTH(3);
/* Do not use packed pixels = one pixel per word instead. */
ctrl1 |= CTRL1_SET_BYTE_PACKAGING(0x7);
break;
default:
dev_err(drm->dev, "Unhandled pixel format %08x\n", format);
return -EINVAL;
}
writel(ctrl1, mxsfb->base + LCDC_CTRL1);
writel(ctrl, mxsfb->base + LCDC_CTRL);
return 0;
}
static void mxsfb_set_bus_fmt(struct mxsfb_drm_private *mxsfb)
{
struct drm_crtc *crtc = &mxsfb->pipe.crtc;
struct drm_device *drm = crtc->dev;
u32 bus_format = MEDIA_BUS_FMT_RGB888_1X24;
u32 reg;
reg = readl(mxsfb->base + LCDC_CTRL);
if (mxsfb->connector.display_info.num_bus_formats)
bus_format = mxsfb->connector.display_info.bus_formats[0];
reg &= ~CTRL_BUS_WIDTH_MASK;
switch (bus_format) {
case MEDIA_BUS_FMT_RGB565_1X16:
reg |= CTRL_SET_BUS_WIDTH(STMLCDIF_16BIT);
break;
case MEDIA_BUS_FMT_RGB666_1X18:
reg |= CTRL_SET_BUS_WIDTH(STMLCDIF_18BIT);
break;
case MEDIA_BUS_FMT_RGB888_1X24:
reg |= CTRL_SET_BUS_WIDTH(STMLCDIF_24BIT);
break;
default:
dev_err(drm->dev, "Unknown media bus format %d\n", bus_format);
break;
}
writel(reg, mxsfb->base + LCDC_CTRL);
}
static void mxsfb_enable_controller(struct mxsfb_drm_private *mxsfb)
{
u32 reg;
if (mxsfb->clk_disp_axi)
clk_prepare_enable(mxsfb->clk_disp_axi);
clk_prepare_enable(mxsfb->clk);
mxsfb_enable_axi_clk(mxsfb);
/* If it was disabled, re-enable the mode again */
writel(CTRL_DOTCLK_MODE, mxsfb->base + LCDC_CTRL + REG_SET);
/* Enable the SYNC signals first, then the DMA engine */
reg = readl(mxsfb->base + LCDC_VDCTRL4);
reg |= VDCTRL4_SYNC_SIGNALS_ON;
writel(reg, mxsfb->base + LCDC_VDCTRL4);
writel(CTRL_RUN, mxsfb->base + LCDC_CTRL + REG_SET);
}
static void mxsfb_disable_controller(struct mxsfb_drm_private *mxsfb)
{
u32 reg;
/*
* Even if we disable the controller here, it will still continue
* until its FIFOs are running out of data
*/
writel(CTRL_DOTCLK_MODE, mxsfb->base + LCDC_CTRL + REG_CLR);
readl_poll_timeout(mxsfb->base + LCDC_CTRL, reg, !(reg & CTRL_RUN),
0, 1000);
reg = readl(mxsfb->base + LCDC_VDCTRL4);
reg &= ~VDCTRL4_SYNC_SIGNALS_ON;
writel(reg, mxsfb->base + LCDC_VDCTRL4);
mxsfb_disable_axi_clk(mxsfb);
clk_disable_unprepare(mxsfb->clk);
if (mxsfb->clk_disp_axi)
clk_disable_unprepare(mxsfb->clk_disp_axi);
}
static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb)
{
struct drm_display_mode *m = &mxsfb->pipe.crtc.state->adjusted_mode;
const u32 bus_flags = mxsfb->connector.display_info.bus_flags;
u32 vdctrl0, vsync_pulse_len, hsync_pulse_len;
int err;
/*
* It seems, you can't re-program the controller if it is still
* running. This may lead to shifted pictures (FIFO issue?), so
* first stop the controller and drain its FIFOs.
*/
mxsfb_enable_axi_clk(mxsfb);
/* Clear the FIFOs */
writel(CTRL1_FIFO_CLEAR, mxsfb->base + LCDC_CTRL1 + REG_SET);
err = mxsfb_set_pixel_fmt(mxsfb);
if (err)
return;
clk_set_rate(mxsfb->clk, m->crtc_clock * 1000);
writel(TRANSFER_COUNT_SET_VCOUNT(m->crtc_vdisplay) |
TRANSFER_COUNT_SET_HCOUNT(m->crtc_hdisplay),
mxsfb->base + mxsfb->devdata->transfer_count);
vsync_pulse_len = m->crtc_vsync_end - m->crtc_vsync_start;
vdctrl0 = VDCTRL0_ENABLE_PRESENT | /* Always in DOTCLOCK mode */
VDCTRL0_VSYNC_PERIOD_UNIT |
VDCTRL0_VSYNC_PULSE_WIDTH_UNIT |
VDCTRL0_SET_VSYNC_PULSE_WIDTH(vsync_pulse_len);
if (m->flags & DRM_MODE_FLAG_PHSYNC)
vdctrl0 |= VDCTRL0_HSYNC_ACT_HIGH;
if (m->flags & DRM_MODE_FLAG_PVSYNC)
vdctrl0 |= VDCTRL0_VSYNC_ACT_HIGH;
/* Make sure Data Enable is high active by default */
if (!(bus_flags & DRM_BUS_FLAG_DE_LOW))
vdctrl0 |= VDCTRL0_ENABLE_ACT_HIGH;
/*
* DRM_BUS_FLAG_PIXDATA_ defines are controller centric,
* controllers VDCTRL0_DOTCLK is display centric.
* Drive on positive edge -> display samples on falling edge
* DRM_BUS_FLAG_PIXDATA_POSEDGE -> VDCTRL0_DOTCLK_ACT_FALLING
*/
if (bus_flags & DRM_BUS_FLAG_PIXDATA_POSEDGE)
vdctrl0 |= VDCTRL0_DOTCLK_ACT_FALLING;
writel(vdctrl0, mxsfb->base + LCDC_VDCTRL0);
mxsfb_set_bus_fmt(mxsfb);
/* Frame length in lines. */
writel(m->crtc_vtotal, mxsfb->base + LCDC_VDCTRL1);
/* Line length in units of clocks or pixels. */
hsync_pulse_len = m->crtc_hsync_end - m->crtc_hsync_start;
writel(set_hsync_pulse_width(mxsfb, hsync_pulse_len) |
VDCTRL2_SET_HSYNC_PERIOD(m->crtc_htotal),
mxsfb->base + LCDC_VDCTRL2);
writel(SET_HOR_WAIT_CNT(m->crtc_htotal - m->crtc_hsync_start) |
SET_VERT_WAIT_CNT(m->crtc_vtotal - m->crtc_vsync_start),
mxsfb->base + LCDC_VDCTRL3);
writel(SET_DOTCLK_H_VALID_DATA_CNT(m->hdisplay),
mxsfb->base + LCDC_VDCTRL4);
mxsfb_disable_axi_clk(mxsfb);
}
void mxsfb_crtc_enable(struct mxsfb_drm_private *mxsfb)
{
mxsfb_crtc_mode_set_nofb(mxsfb);
mxsfb_enable_controller(mxsfb);
}
void mxsfb_crtc_disable(struct mxsfb_drm_private *mxsfb)
{
mxsfb_disable_controller(mxsfb);
}
void mxsfb_plane_atomic_update(struct mxsfb_drm_private *mxsfb,
struct drm_plane_state *state)
{
struct drm_simple_display_pipe *pipe = &mxsfb->pipe;
struct drm_crtc *crtc = &pipe->crtc;
struct drm_framebuffer *fb = pipe->plane.state->fb;
struct drm_pending_vblank_event *event;
struct drm_gem_cma_object *gem;
if (!crtc)
return;
spin_lock_irq(&crtc->dev->event_lock);
event = crtc->state->event;
if (event) {
crtc->state->event = NULL;
if (drm_crtc_vblank_get(crtc) == 0) {
drm_crtc_arm_vblank_event(crtc, event);
} else {
drm_crtc_send_vblank_event(crtc, event);
}
}
spin_unlock_irq(&crtc->dev->event_lock);
if (!fb)
return;
gem = drm_fb_cma_get_gem_obj(fb, 0);
mxsfb_enable_axi_clk(mxsfb);
writel(gem->paddr, mxsfb->base + mxsfb->devdata->next_buf);
mxsfb_disable_axi_clk(mxsfb);
}