blob: 137db38f0d27b1c7f9e6ebf218f2fa5924af9401 [file] [log] [blame]
// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include "imx6q-ba16.dtsi"
/ {
model = "Advantech DMS-BA16";
compatible = "advantech,imx6q-dms-ba16", "advantech,imx6q-ba16", "fsl,imx6q";
reg_usb_otg_vbus: regulator-usbotgvbus {
compatible = "regulator-fixed";
regulator-name = "usb_otg_vbus";
regulator-min-microvolt = <5000000>;
regulator-max-microvolt = <5000000>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usbotgvbus>;
gpio = <&gpio4 15 GPIO_ACTIVE_HIGH>;
enable-active-high;
};
sys_mclk: clock-sys-mclk {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-frequency = <22000000>;
};
sound {
compatible = "fsl,imx6q-ba16-sgtl5000",
"fsl,imx-audio-sgtl5000";
model = "imx6q-ba16-sgtl5000";
ssi-controller = <&ssi1>;
audio-codec = <&sgtl5000>;
audio-routing =
"MIC_IN", "Mic Jack",
"Mic Jack", "Mic Bias",
"Headphone Jack", "HP_OUT";
mux-int-port = <1>;
mux-ext-port = <4>;
};
};
&ecspi5 {
cs-gpios = <&gpio1 17 GPIO_ACTIVE_LOW>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_ecspi5>;
status = "okay";
m25_eeprom: flash@0 {
compatible = "atmel,at25256B", "atmel,at25";
spi-max-frequency = <20000000>;
size = <0x8000>;
pagesize = <64>;
reg = <0>;
address-width = <16>;
};
};
&iomuxc {
pinctrl_i2c1_gpio: i2c1gpiogrp {
fsl,pins = <
MX6QDL_PAD_CSI0_DAT8__GPIO5_IO26 0x1b0b0
MX6QDL_PAD_CSI0_DAT9__GPIO5_IO27 0x1b0b0
>;
};
pinctrl_i2c2_gpio: i2c2gpiogrp {
fsl,pins = <
MX6QDL_PAD_KEY_COL3__GPIO4_IO12 0x1b0b0
MX6QDL_PAD_KEY_ROW3__GPIO4_IO13 0x1b0b0
>;
};
pinctrl_i2c3_gpio: i2c3gpiogrp {
fsl,pins = <
MX6QDL_PAD_GPIO_3__GPIO1_IO03 0x1b0b0
MX6QDL_PAD_GPIO_6__GPIO1_IO06 0x1b0b0
>;
};
pinctrl_usbotgvbus: usbotgvbusgrp {
fsl,pins = <
MX6QDL_PAD_ENET_RX_ER__USB_OTG_ID 0x17059
MX6QDL_PAD_KEY_ROW4__GPIO4_IO15 0x000b0
>;
};
};
&i2c1 {
clock-frequency = <100000>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_i2c1>;
status = "okay";
sgtl5000: codec@a {
compatible = "fsl,sgtl5000";
reg = <0x0a>;
clocks = <&sys_mclk>;
lrclk-strength = <0x3>;
VDDA-supply = <&reg_1p8v>;
VDDIO-supply = <&reg_3p3v>;
};
};
&pwm2 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_pwm2>;
status = "okay";
};
&sata {
fsl,no-spread-spectrum;
fsl,transmit-atten-16ths = <12>;
fsl,transmit-boost-mdB = <3330>;
fsl,transmit-level-mV = <1133>;
fsl,receive-dpll-mode = <1>;
status = "okay";
};
&usbotg {
vbus-supply = <&reg_usb_otg_vbus>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usbotg>;
dr_mode = "otg";
disable-over-current;
status = "okay";
};
&usdhc4 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usdhc4>;
bus-width = <8>;
cd-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>;
no-1-8-v;
keep-power-in-suspend;
wakeup-source;
status = "okay";
};