| Samsung S5K6A3(YX) raw image sensor |
| --------------------------------- |
| |
| S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces |
| and CCI (I2C compatible) control bus. |
| |
| Required properties: |
| |
| - compatible : "samsung,s5k6a3"; |
| - reg : I2C slave address of the sensor; |
| - svdda-supply : core voltage supply; |
| - svddio-supply : I/O voltage supply; |
| - afvdd-supply : AF (actuator) voltage supply; |
| - gpios : specifier of a GPIO connected to the RESET pin; |
| - clocks : should contain list of phandle and clock specifier pairs |
| according to common clock bindings for the clocks described |
| in the clock-names property; |
| - clock-names : should contain "extclk" entry for the sensor's EXTCLK clock; |
| |
| Optional properties: |
| |
| - clock-frequency : the frequency at which the "extclk" clock should be |
| configured to operate, in Hz; if this property is not |
| specified default 24 MHz value will be used. |
| |
| The common video interfaces bindings (see video-interfaces.txt) should be |
| used to specify link to the image data receiver. The S5K6A3(YX) device |
| node should contain one 'port' child node with an 'endpoint' subnode. |
| |
| Following properties are valid for the endpoint node: |
| |
| - data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in |
| video-interfaces.txt. The sensor supports only one data lane. |
